The only adjustable rear swaybar mounts on the market! We did a bit of engineering with this one, trying to figure out a way to get a little bit more adjustability out of a simple mount. These new mounts give you two parallel positions and allow you to "angle" your swaybar for the ultimate performance on the road or an oval track!
BAJA REAR SWAYBAR MOUNT
INSTALL
·
Contests of kit include 2 machined AL sway bar mounts, 6 machined AL cone
washers, 2-M3x25 flat socket screws, 4-M3x8 flat socket screws & 2-M3x4
socket set screws.
·
First remove the weak stock plastic sway bar
mounts. Verify that the two M3 locknuts are still in place inside the
rear bulkhead.
·
Snap the two new aluminum sway bar mounts
in place as in picture above. They will be tight fitting on the stock
plastic.
·
If needed, use the four small M3x4 socket
set screws on the inside of the
slots as shown (Make sure to use loctite on these little set screws). These
prevent vibration and noise when using the medium and small sway bar size
wires. You do not need to use these if running the thick sway bar
wire.
·
Now chose the position you would like to
mount the sway bar wire in. You can use the upper or lower mounting position or you can
use the angled position if you use the medium or small size wire. The
large wire will not bend for the angled install.
·
Use one cone washer for every screw
starting with the two M3x25 screws in the upper holes, then the four M3x8
screws in the lower holes.
·
That's it. You're done! Just
remember, use loctite!
